Right Wallpaper
Prepare for wallpaper glueing. This procedure consists of the following: the wallpaper is cut one or two edges, and edges are cut severely on the existing lines, and cut the roll into individual sheets. Wallpaper paste either butt or overlap. Filed under: Vicky Jenson. The first method is recommended when working with the wallpaper has secondary and higher quality, and thin wallpaper paste usually overlap. In this case, the edge of the blade should be imposed pay to the light to shadow falling on the seam line is not stressed joint. Thus, if the wall is glued on the right side of the window should be cut off the left edge, and if the wall is glued to the left of the window, the right edge. After the first panel is ready, you can start processing the second. In this case, you should exercise the utmost accuracy, because now you need to combine previously part of the picture wallpaper that the wall was intact.
When cutting panels from the roll will have to leave just in case a small (2-2.5 cm) margin height walls: sometimes it happens that in the same room height of the walls is not the same, also in the process gluing wallpaper give a little shrinkage. In any case, the excess is always better than a shortage – it will become clear in the process. A part of the excess cloth wallpaper, the rest of the floor, at the end of the work can be carefully cut special knife. The cut of cloth wallpaper should be put face to the floor (by the way, lay a good pre-his old newspapers or plastic sheeting to protect against contamination of the adhesive), and lateral edge of each blade to the next act in the direction of about 2 cm – it is done in order not to stain the front side of the adhesive wallpaper.
| Posted in News | Comments Off on Right Wallpaper